Подшипник INA MKUVE20-B-ZR INA / FAG

Print

Linear actuators
Описание:
"
H110 -mm -
 - -
B86 -mm -
 - -
L250 -mm -
 - -
 -
1) -
 -L2 = total stroke + L1 + 12
L tot = total stroke + L1 + 12 + 2 x L4
Total stroke = effective stroke + 2 x S (mm)

ATTENTION: The allowance S designates a safety range и should be at least 85 mm.

Maximum support rail length 8000 mm.
2) -
 -Funnel type lubrication nipple to DIN 3405-AM6
B140 -mm -
 - -
B440 -mm -
 - -
B788 -mm -
 - -
B86 -mm -
 -Tolerance: P9- DIN 6885-1 Pattern A
D110 -mm -
 - -
D310 -mm -
 -Utilisation of the T-slots is restricted by the holes.
H153,4 -mm -
 - -
H2101,4 -mm -
 - -
H320 -mm -
 - -
H460 -mm -
 - -
H590 -mm -
 - -
L1260 -mm -
 - -
L497 -mm -
 - -
L548 -mm -
 - -
L636 -mm -
 -Utilisation of the T-slots is restricted by the holes.
L759,5 -mm -
 -Utilisation of the T-slots is restricted by the holes.
OM6 -
 - -
 -
mtot(Ltot - 194) x 0,0124 + 6 -kg -
 -Вес
mLaw2 -kg -
 -Вес of carriage
C21,3 -kN -
 -Basic load ratings of carriage guidance system

ATTENTION: Values are valid only for calculating Lh.
C054 -kN -
 -Basic load ratings of carriage guidance system

ATTENTION: Values are valid only for calculating Lh.
M0x per664 -Nm -
 -Permissible moments on carriage guidance system

The values are single loads и apply when the underside of the actuator is fully supported.
These must be reduced for combined loads.
M0y per1900 -Nm -
 -Permissible moments on carriage guidance system

The values are single loads и apply when the underside of the actuator is fully supported.
These must be reduced for combined loads.
M0z per1700 -Nm -
 -Permissible moments on carriage guidance system

The values are single loads и apply when the underside of the actuator is fully supported.
These must be reduced for combined loads.
ly300 -cm^4 -
 -Geometrical moments of inertia of support rail
lz198 -cm^4 -
 -Geometrical moments of inertia of support rail
 -50 AT 10 -
 -Toothed belt
 -1880 -N -
 -Permissible toothed belt operating force
 -68,8 -Nm -
 -Maximum drive torque
 -0,315 -kg/m -
 -Вес of toothed belt
 -200 -mm/Umdr -
 -Feed (mm/revolution)
 -5 x 10^-4 -kg x m^2 -
 -Вес moment of inertia of both gears
"

Подшипник INA / FAG MKUVE20-B-ZR

INA / FAG MKUVE20-B-ZR
Наличие: Уточняйте

Поставщик:

(812) 327-79-70

«...назад