| mLaw | 3,8 -kg - | |
| mtot | (Ltot - 231) x 0,0169 + 12 -kg - | |
| - | - | | - | L2 = total stroke + L1 + 12
L tot = total stroke + L1 + 12 + 231
Total stroke = effective stroke + 2 x S
The allowance S designates a safety range suitable for the particular application и should be at least 85 mm- total stroke in mm.
Maximum single-piece support rail length L2 = 8000 mm. |
|
| ly | 712 -cm^4 - | | - | Geometrical moments of inertia |
|
| lz | 506 -cm^4 - | | - | Geometrical moments of inertia |
|
| - | 50 AT 10 - | |
| - | 1880 -N - | | - | Permissible toothed belt operating force |
|
| - | 75 -Nm - | |
| - | 0,315 -kg/m - | |
| - | 250 -mm/Umdr - | |
| - | 14,7 x 10^-4 -kg x m^2 - | | - | Вес moment of inertia of both gears |
|
| CI | 45500 -N - | | - | Basic load ratings for linear recirculating ball bearing и guideway assembly
Load direction I = compressive load
ATTENTION: Values are valid only for calculating Lh. |
|
| C0 I | 134000 -N - | | - | Basic load ratings for linear recirculating ball bearing и guideway assembly
Load direction I = compressive load
ATTENTION: Values are valid only for calculating Lh. |
|
| CII | 37200 -N - | | - | Basic load ratings for linear recirculating ball bearing и guideway assembly
Load direction II = tensile load
ATTENTION: Values are valid only for calculating Lh. |
|
| C0 II | 86000 -N - | | - | Basic load ratings for linear recirculating ball bearing и guideway assembly
Load direction II = tensile load
ATTENTION: Values are valid only for calculating Lh. |
|
| CIII | 34600 -N - | | - | Basic load ratings for linear recirculating ball bearing и guideway assembly
Load direction III = lateral load
ATTENTION: Values are valid only for calculating Lh. |
|
| C0 III | 92000 -N - | | - | Basic load ratings for linear recirculating ball bearing и guideway assembly
Load direction III = lateral load
ATTENTION: Values are valid only for calculating Lh. |
|
| M0x | 1070 -Nm - | | - | Permissible static moment on linear guidance system:
The values are single loads и apply when the underside of the actuator is fully supported.
These must be reduced for combined loads.
For design criteria of the linear guidance system, see Catalogue PF1. |
|
| M0y | 2250 -Nm - | | - | Permissible static moment on linear guidance system:
The values are single loads и apply when the underside of the actuator is fully supported.
These must be reduced for combined loads.
For design criteria of the linear guidance system, see Catalogue PF1. |
|
| M0z | 2000 -Nm - | | - | Permissible static moment on linear guidance system:
The values are single loads и apply when the underside of the actuator is fully supported.
These must be reduced for combined loads.
For design criteria of the linear guidance system, see Catalogue PF1. |
|
