mLaw | 14,1 -kg - | |
mtot | (Ltot - 231) x 0,0325 + 30 -kg - | |
ly | 7069 -cm^4 - |  - | Geometrical moments of inertia |
|
lz | 899 -cm^4 - |  - | Geometrical moments of inertia |
|
CI | 42700 -N - |  - | Basic load ratings:
ATTENTION: Values are valid only for calculating Lh. |
|
C0 I | 83600 -N - |  - | Basic load ratings:
ATTENTION: Values are valid only for calculating Lh. |
|
CII | 42700 -N - |  - | Basic load ratings:
ATTENTION: Values are valid only for calculating Lh. |
|
C0 II | 83600 -N - |  - | Basic load ratings:
ATTENTION: Values are valid only for calculating Lh. |
|
CIII | 42700 -N - |  - | Basic load ratings:
ATTENTION: Values are valid only for calculating Lh. |
|
C0 III | 83600 -N - |  - | Basic load ratings:
ATTENTION: Values are valid only for calculating Lh. |
|
M0x | 5500 -Nm - |  - | Permissible static moment on linear guidance system: The values are single loads и apply when the underside of the actuator is fully supported. These must be reduced for combined loads. For design criteria of the linear guidance system, see Catalogue PF1. |
|
M0y | 5300 -Nm - |  - | Permissible static moment on linear guidance system: The values are single loads и apply when the underside of the actuator is fully supported. These must be reduced for combined loads. For design criteria of the linear guidance system, see Catalogue PF1. |
|
M0z | 5400 -Nm - |  - | Permissible static moment on linear guidance system: The values are single loads и apply when the underside of the actuator is fully supported. These must be reduced for combined loads. For design criteria of the linear guidance system, see Catalogue PF1. |
|
 - | 50AT10 - | |
 - | 5640 -N - |  - | Permissible toothed belt operating force |
|
 - | 207 -Nm - |  - | Maximum drive torque |
|
 - | 230 -mm/Umdr - |  - | Feed (mm/revolution) |
|
 - | 35,2 x 10^-4 -kg x m^2 - |  - | Вес moment of inertia of both gears |
|
 - |  - |  - | L2 = total stroke + L1 + 12 L tot = total stroke + L1 + 12 + 2 x L4 Total stroke = effective stroke + 2 x S.
ATTENTION: The allowance S designates a safety range suitable for the particular application и should be at least 85 mm- total stroke in mm.
Maximum single-piece support rail length L2 = 6000 mm. |
|