| - | 0 / -16 -µ-m - | |
| - | +6 / -5 -µ-m - | | - | Special tolerance j5: Only for shafts made from quenched и tempered steel. |
|
| - | - | | - | Axial threaded hole:
G2 = M10 / M12 / M16
Radial threaded hole:
jL = 150 / 200 / 300 mm
aL = 20 mm (hole pattern 03)
aR = 3 x G2 + G7 (hole pattern 04 - 05)
aL и aR are dependent on the shaft length.
For designs with hole patterns 04 и 05, the axial threaded holes must be taken into consideration.
T7 = 19 mm
T8 = 4 mm
N3 = 11 mm
G7 = M10 |
|
| - | - | | - | Axial threaded hole:
G2 = M10 / M12 / M16
Radial threaded hole:
jL = 100 mm
aL = 20 mm (hole pattern 03)
aR = 3 x G2 + G7 (hole pattern 04 - 05)
aL и aR are dependent on the shaft length.
For designs with hole patterns 04 и 05, the axial threaded holes must be taken into consideration.
T7 = 21 mm
T8 = 4 mm
N3 = 13 mm
G7 = M12 |
|
| 01 | - | | - | Code 01
Axial threaded hole on one side |
|
| 02 | - | | - | Code 02
Axial threaded holes on both sides |
|
| 03 | - | | - | Code 03
Radial threaded holes |
|
| 04 | - | | - | Code 04
Radial threaded holes и axial threaded hole on one side |
|
| 05 | - | | - | Code 05
Radial threaded holes и axial threaded holes on both sides |
|
| Rhtmin | 1,5 -mm - | | - | Surface hardening depth:
To DIN ISO 13012 |
|
| t1 | 7 -µ-m - | |
| t2 | 11 -µ-m - | | - | Parallelism:
Measured diameter deviation. |
|
