| - | 0 / -13 -µ-m - | |
| - | +5 / -4 -µ-m - | | - | Special tolerance j5: Only for shafts made from quenched и tempered steel. |
|
| - | -20 / -41 -µ-m - | | - | Special tolerance f7: Only for shafts made from quenched и tempered steel. |
|
| - | - | | - | Radial threaded hole:
jL = 150 mm
aL = 15 mm (hole pattern 03)
aR = 3 x G2 + G7 (hole pattern 04 - 05)
aL и aR are dependent on the shaft length.
For designs with hole patterns 04 и 05, the axial threaded holes must be taken into consideration.
T7 = 9 mm
T8 = 2,5 mm
N3 = 6 mm
G7 = M5 |
|
| - | - | | - | Axial threaded hole:
G2 = M6 / M8 / M10
Radial threaded hole:
jL = 75 / 100 / 150 mm
aL = 15 mm (hole pattern 03)
aR = 3 x G2 + G7 (hole pattern 04 - 05)
aL и aR are dependent on the shaft length.
For designs with hole patterns 04 и 05, the axial threaded holes must be taken into consideration.
T7 = 11 mm
T8 = 3 mm
N3 = 7 mm
G7 = M6 |
|
| 01 | - | | - | Code 01
Axial threaded hole on one side |
|
| 02 | - | | - | Code 02
Axial threaded holes on both sides |
|
| 03 | - | | - | Code 03
Radial threaded holes |
|
| 04 | - | | - | Code 04
Radial threaded holes и axial threaded hole on one side |
|
| 05 | - | | - | Code 05
Radial threaded holes и axial threaded holes on both sides |
|
| Rhtmin | 0,9 -mm - | | - | Surface hardening depth:
To DIN ISO 13012 |
|
| t1 | 6 -µ-m - | |
| t2 | 9 -µ-m - | | - | Parallelism:
Measured diameter deviation. |
|
