Подшипник INA W16 INA / FAG

Print

Solid shafts
Описание:
"
dLW16 -mm -
 - -
L6000 -mm -
 - -
 -
 -0 / -11 -µ-m -
 -Tolerance h6
 -+5 / -3 -µ-m -
 -Special tolerance j5: Only for shafts made from quenched и tempered steel.
 --16 / -34 -µ-m -
 -Special tolerance f7: Only for shafts made from quenched и tempered steel.
 - -
 -Axial threaded hole:
G2 = M5 / M6 / M8

Radial threaded hole:
jL = 75 / 100 / 150 mm
aL = 15 mm (hole pattern 03)
aR = 3 x G2 + G7 (hole pattern 04 - 05)
aL и aR are dependent on the shaft length.
For designs with hole patterns 04 и 05, the axial threaded holes must be taken into consideration.
T7 = 9 mm
T8 = 2,5 mm
N3 = 6 mm
G7 = M5
01 -
 -Code 01
Axial threaded hole on one side
02 -
 -Code 02
Axial threaded holes on both sides
03 -
 -Code 03
Radial threaded holes
04 -
 -Code 04
Radial threaded holes и axial threaded hole on one side
05 -
 -Code 05
Radial threaded holes и axial threaded holes on both sides
Rhtmin0,6 -mm -
 -Surface hardening depth:
To DIN ISO 13012
t15 -µ-m -
 -Roundness
t28 -µ-m -
 -Parallelism:
Measured diameter deviation.
 -
mW1570 -g/m -
 -Вес of shaft
 - -
 -For designs with hole patterns 04 и 05, the axial thread must be taken into consideration.
"

Подшипник INA / FAG W16

INA / FAG W16
Наличие: Уточняйте

Поставщик:

(812) 327-79-70

«...назад